JEEP® WRANGLER FAQ

VEHICLE SPECS AND PERFORMANCE

The 2026 Jeep® Wrangler boasts the following horsepower and torque ratings depending on the selected engine:

 

  • 2.0L Turbo I4 Engine: 270 Horsepower; 295 Pound-Feet of Torque
  • 3.6L Pentastar® V6 Engine: 285 Horsepower; 260 Pound-Feet of Torque

Both the 2.0L Turbo I4 engine and 3.6L Pentastar® V6 engine available on the Jeep® Wrangler will meet all emissions requirements and provide impressive efficiency and performance when using high-quality unleaded regular gasoline having an octane rating of 87, as specified by the (R+M)/2 method. For the 2.0L Turbo I4 engine, use of 91 or higher-octane premium gasoline will allow this engine to achieve optimal performance.

The fuel tank of the 2026 Jeep® Wrangler holds varying amounts of fuel depending on the model:

 

  • Wrangler 2-Door models hold 17.5 gallons of fuel
  • Wrangler 4-Door models hold 21.5 gallons of fuel

The base curb weights for the 2026 Jeep® Wrangler are:

 

  • 2-Door: 4,005 to 4,422 pounds
  • 4-Door (non-PHEV): 4,251 to 4,976 pounds

 

The Gross Vehicle Weight Rating of the 2026 Jeep® Wrangler ranges between 5,100 and 6,250 pounds.  

The length of the 2026 Jeep® Wrangler depends on the model. The 2-door Wrangler is 166.8 inches, the 2-door Wrangler with the Xtreme 35-Inch Tire Package is 170.9 inches, the 4-door model is 188.4 inches and the Wrangler 4-door with the available Xtreme 35-inch Tire Package is 192.5 inches. 

The width of all 2026 Wrangler models is 73.9 inches except for the Wrangler 4-door with the available Xtreme 35-inch Tire Package, which is 79.3 inches wide.

The standard height of the 2026 Jeep® Wrangler is up to 73.6 inches, while the Xtreme 35-Inch Tire Package gives the vehicle a height of 75.5 inches.

TOWING, DRIVETRAIN AND CAPABILITY

The 2026 Jeep® Wrangler comes with one of four standard and available 4x4 systems. The Command-Trac® 4x4 System (2.72:1 low ratio) is a part-time system, which provides the driver the ability to change into four different drive modes: Neutral, 4Low, 4Hi and 2WD. To engage 4Low Mode on this system, ensure the transmission is in neutral while traveling at low speed and move the shift lever into the 4Low position. Then return the transmission to the required gear. Reverse the process to shift into 4Hi Mode. 4Low and 4Hi will always keep 4WD engaged when selected.

 

The Rock-Trac® 4x4 System (4:1 low ratio) comes standard in a part-time system or a full-time system, depending on model. The part-time system follows the same driver-intervention instructions described for the Command-Trac® 4x4 System above.

 

The Rock-Trac® 4x4 Full-Time System provides the same four drive modes described above, but adds a 4Hi Auto Mode. This mode actively manages front and rear torque distribution based on traction needs. Unlike a part-time system, this full-time system is designed for constant use across all surfaces where part-time systems are intended for loose, slippery road surfaces only and not intended for normal driving.  

 

The available Selec-Trac® 4x4 System (2.72:1 low ratio) is also a full-time system.

To switch from 2H to 4H in a 2026 Jeep® Wrangler with an automatic transmission, first slow your vehicle to under 55 mph. Then shift the transfer case lever to the left of the gear shifter from the "2HI" position to the "4HI" position.

The 2026 Jeep® Wrangler 4-door can tow up to a maximum of 5,000 pounds when properly equipped. The 2026 Jeep Wrangler 2-door can tow up to a maximum of 2,000 pounds, when properly equipped.

If properly equipped, the 2026 Jeep® Wrangler can pull most small campers. When properly equipped, the maximum towing capacity of a Wrangler 4-door is 5,000 pounds, which is about the weight of your average small camper.

To flat-tow a 2026 Jeep® Wrangler, you should make sure that a) your Wrangler is properly equipped to be flat-towed, and b) that the vehicle pulling the Wrangler has enough towing capacity to haul the SUV. For the record, the Gross Vehicle Weight Rating of the 2026 Jeep® Wrangler ranges between 5,000 and 6,100 pounds. Here’s a breakdown for various models’ weights:

 

  • 2-Door: 4,014 to 4,429 pounds
  • 4-Door: 4,287 to 4,976 pounds

 

If your towing vehicle can accommodate the weight of the Wrangler, simply attach the tow arm of your vehicle to the two brackets on the front of the Wrangler.

MODEL TYPES AND COMPARISON

Yes, the 2026 Jeep® Wrangler is classified as an SUV. All 2026 Jeep Wrangler models are Trail Rated® and boast different available levels of legendary capability, authentic open-air freedom and unmistakable Jeep Brand style.

Learn about the 2026 Jeep® Wrangler models using the Compare Models tool.

The 2026 Jeep® Wrangler JL is the refined, fourth generation of the Jeep Brand’s iconic SUV. It was first released to the public in 2018. Available in 2-door or 4-door options, "JL" is the model code used by FCA US LLC for current-generation Wrangler models.

The Jeep® Wrangler JK is the third generation of the Jeep Brand’s iconic SUV. It was unveiled in 2006 at the North American International Auto Show. "JK" is a model code used by FCA US LLC for current-generation Wrangler models.

CUSTOMIZATION AND FEATURES

You can wirelessly connect compatible smartphones to the 2026 Jeep® Wrangler through Apple CarPlay® support or Android Auto™ compatibility, both included with the Uconnect® system in the vehicle.

Removing the three-piece Freedom Top® Hardtop from the 2026 Jeep® Wrangler is easy. To learn how, play this video(Open in a new window).

The enhanced door hinge system makes door removal quicker and easier than ever for open-air freedom.

 

Check out this instructional video to learn how our easy-release door hinge system works.

 

Play Video(Open in a new window)